There are three manipulating ways: automatism, hand control and hand work. Automatism can greatly cut the labor cost, improve the consistency of production and reduce the waste water. The way of hand control is easy to manipulate; the handlers can use various kinds of methods to do the work. The difference between hand control and hand work is that in the formal one, workers portage the work piece by hand so it requires high intensity. But in the latter process, traveling cranes are used the portage the work piece.
| items |
unit |
main technology parameter |
postscript |
| Level speed of traveling crane |
m/min |
10-40 |
Depending on production and load |
| Vertical speed of traveling crane |
m/min |
8-28 |
Depending on production and load |
| Cathode moving frequency |
times/min |
10-20 |
Level moving or upward
or downward moving |
| swing |
mm |
60-100 |
| Load of pole stick |
kg/stick |
100-500 |
Sometimes can reach 1500kg/stick |
| Load of platen |
kg/roll |
10-60 |
Can be changed according to the special order |
 Low orbit product line
The surface of the guiding orbit is at the same level or higher than the level of the trough.
Rectangle poles are used in the guiding orbit and the stand pole. The guiding orbit and the stand pole make the whole frame, sitting on the level ground. The do not need any other base.
Suspend load≤1000kg |
|
|
|
Middle orbit traveling crane product line
Points:
The surface of the guiding orbit is near the center of gravity of the traveling crane.
Structure one: Rectangle poles are used in the guiding orbit and the stand pole.
Structure two: the guiding orbit (rectangle pipe) +bearing girder (profiled bar)
Base is needed for the stand pole.
Suspend load≤1500kg |
|
|
|
|
 High orbit traveling crane product line
Points:
The surface of the guiding orbit is on the top of the traveling crane or in the space left in the construction.
Structure one: According to the frame of the traveling crane, whole structure is adopted. Bearing girder and the stand pole is profiled bar.
Structure two: the guiding orbit and bearing girder is on the construction component.
Base is needed for the stand pole.
Suspend load≤1000kg
|
|
|
|
|
|
|
Hanging arm product line
The guiding orbit and the stand pole are in the non-operating side.
Suspend load≤80kg |
|
|
|
